Tuesday, June 27, 2017
   
Text Size

Search

Search Keyword make Total: 10 results found.

Search Result

  1. Monday Update 1/18/10

    Category: Blog/Blog

    ... without adding any holes to the vehicle.  It is our intention to make this camera mount system available to the public, but you get a sneak peak today.  The system could be wired to run so the driver can ...
    Tuesday, 19 January 2010
  2. Motor Mounts

    Category: Products/DVS Engineered Products

    ... mount points and lower the motor enough to make it clear the original hood in most cases. These brackets are a two piece design like the originals to aid in installation. They also come with the following ...
    Monday, 31 August 2009
  3. IRS Subframe Cradle Drop

    Category: Uncategorised Content

    ... to the rack. There is a hole on each side of the cradle. I use a long bolt and use these two holes to help align the cradle. Make sure you get the inside/outside ...
    Wednesday, 20 January 2010
  4. Lowered Expectations

    Category: Uncategorised Content

    ... to cut out the entire axle snubber assemblies. They will interfere with the travel of the upper control arm. For some applications you will have to dimple or modify the trunk area to make clearance ...
    Monday, 14 September 2009
  5. Attention 65-66 Mustang Owners

    Category: Uncategorised Content

    ... have a quick answer. The 1965 fastback above was going to be used as our guide for any changes that would need to be done to make our system fit the early cars. What we didn't know at the time is that ...
    Monday, 14 September 2009
  6. IRS Facts, Fiction, and Useless (and Useful) Trivia

    Category: Uncategorised Content

    ... the 2000 R unit make it to the 2003-2004 units. 31 spline axles (slightly shorter) 3.55 gears (standard posi and not the expensive Gerodisc), stiffer but not as stiff as the R units rubber subframe bushings, ...
    Monday, 14 September 2009
  7. Restorations

    Category: Uncategorised Content

    ... Generic restorations simply don't cut it anymore. DVS Restorations knows Mustangs, and if we don't know about a particular concours detail, we'll find out and make it right before beginning any work. We ...
    Monday, 31 August 2009
  8. Welcome to Dave Stribling Restorations

    Category: Uncategorised Content

    ... modern muscle machine, we look forward to helping you make your dream car come true.  ...
    Thursday, 27 August 2009
  9. Mac Strut Update

    Category: Blog/Blog

    ... squeemish.  Because of this, we want to make sure that our instructions are clear and precise before we have people cutting the front end of their cars apart, only to get stuck or install it wrong. 2. ...
    Wednesday, 14 May 2008
  10. Canton Front Sump Oil Pans Are Here!

    Category: Blog/Blog

    ... clears the stock windage tray.     The good people at Canton Racing have once again brought us another one of their forward thinking products, and we are proud to make it available to you.  Canton's ...
    Tuesday, 28 February 2006
Search Parameters
Search Only: